我是一个新手,从网络上查询了CISCO路由器关于NAT配置的文章,可是其中有一条命令: ip nat pool在我的2610路由器上怎么也找不到。 在CONFIG模式下,我的路由器只有ip nat inside ip nat service ip nat translation 3条选项 下面是SH VER的内容 cisco2600#sh ver Cisco Internetwork Operating System Software IOS (tm) C2600 Software (C2600-I-M), Version 11.3(10)T, RELEASE SOFTWARE (fc1 ) Copyright (c) 1986-1999 by cisco Systems, Inc. Compiled Tue 01-Jun-99 17:16 by pwade Image text-base: 0x80008084, data-base: 0x80566960
ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
cisco2600 uptime is 4 hours, 54 minutes System restarted by power-on System image file is "Flash:c2600-i-mz.113-10.T", booted via flash
cisco 2610 (MPC860) processor (revision 0x203) with 12288K/12288K bytes of mem or y. Processor board ID JAD03449241 (1143084682) M860 processor: part number 0, mask 49 Bridging software. X.25 software, Version 3.0.0. 1 Ethernet/IEEE 802.3 interface(s) 2 Serial(sync/async) network interface(s) 32K bytes of non-volatile configuration memory. 8192K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102 请教各位高手该如何配置我的路由器? --